AVR Drivers: Difference between revisions
m
→Upload new settings
Line 180: | Line 180: | ||
The :w: part of the command tells the programmer to <u>w</u>rite settings from the files for flash memory and eeprom and to set the values of the low and high fuses to the hexadecimal values shown. :a is for automatic file type detection, :m indicates "immediate mode" (use the hex values given). | The :w: part of the command tells the programmer to <u>w</u>rite settings from the files for flash memory and eeprom and to set the values of the low and high fuses to the hexadecimal values shown. :a is for automatic file type detection, :m indicates "immediate mode" (use the hex values given). | ||
Always keep low fuse at 0x7F or lower value to ensure that SPI programming is enabled. Values 0x80 or higher will lock the ATtiny13A and it could only be reset in other more complicated ways. | |||
==Compile your own code== | ==Compile your own code== |