AVR Drivers: Difference between revisions
→Set up your clip
(add picture of Atmel and tables of pin numbers) |
|||
| Line 75: | Line 75: | ||
|} | |} | ||
So Wire 1 (MOSI) of the ribbon cable from the programmer must attach to Pin | So Wire 1 (MOSI) of the ribbon cable from the programmer must attach to Pin 5 of the Atmel. Make sure you mark which end of the clip attaches to the top of the Atmel or everything will be misaligned next time you use it. Line up RST and SCK with their appropriate wires. But notice that MISO on the programmer is Wire number 9 and the ribbon only has 8 wires. You will need to disassemble the end of the ribbon cable at the controller end and move wire 8 over to the 9 position so that MISO lines up correctly. | ||
==Download settings== | ==Download settings== | ||