confirmed, developer
1,668
edits
Difference between revisions of "Terminology"
add reflow
(add CW, NW, and WW, rewrite titanium) |
(add reflow) |
||
| Line 180: | Line 180: | ||
;recoil: or "recoil thrower" is a flashlight design where the LED is mounted on an arm just under the center of the lens, facing backwards into the reflector. Such a light can produce a very intense hotspot with great throw and very little spill. One downside is there is not much heatsinking to carry heat away from the LED. | ;recoil: or "recoil thrower" is a flashlight design where the LED is mounted on an arm just under the center of the lens, facing backwards into the reflector. Such a light can produce a very intense hotspot with great throw and very little spill. One downside is there is not much heatsinking to carry heat away from the LED. | ||
;reflow: or "reflow soldering," a technique used to solder surface mount devices to pads on circuit boards. The pads have a little solder, then the device to be mounted is put in place and the entire board is heated until the solder melts. This is how LED's are usually attached to their star or board. The heating can be done on the stove, in an oven, or with a hot air gun. See [http://en.wikipedia.org/wiki/Reflow_soldering Wikipedia article]. | |||
;regulator: in a flashlight, a circuit that takes energy from a battery and converts it to a (usually) constant current or voltage to feed the flashlight's light element (either an LED or bulb). Using a regulator, the flashlight's brightness usually stays constant for the majority of the lifetime of the battery, and then output drops quickly and significantly as the battery is no longer able to supply the required energy. Non-regulated flashlights (also called direct-drive) usually start out at a high output, and then the output diminishes gradually over the lifetime of the battery. See article [[Driver]]. | ;regulator: in a flashlight, a circuit that takes energy from a battery and converts it to a (usually) constant current or voltage to feed the flashlight's light element (either an LED or bulb). Using a regulator, the flashlight's brightness usually stays constant for the majority of the lifetime of the battery, and then output drops quickly and significantly as the battery is no longer able to supply the required energy. Non-regulated flashlights (also called direct-drive) usually start out at a high output, and then the output diminishes gradually over the lifetime of the battery. See article [[Driver]]. | ||