confirmed, developer
1,668
edits
Difference between revisions of "Terminology"
no edit summary
(add noctigon) |
|||
| Line 155: | Line 155: | ||
;Nailbender: a CPF member who makes high power P60 and other drop-ins for host lights. | ;Nailbender: a CPF member who makes high power P60 and other drop-ins for host lights. | ||
;Noctigon: name | ;<span id="Noctigon">Noctigon</span>: a brand name of copper LED MCPCB that is designed to conduct heat away from an LED more efficiently than typical aluminum boards, therefore keeping the LED cooler, increasing brightness and LED life. Also see [[#SinkPAD|SinkPAD]]. | ||
;NW: Neutral White, an LED tint. Should be just pure white, but realistically may have a vanilla, or light yellow or orange tint. See article [[ANSI White]]. | ;NW: Neutral White, an LED tint. Should be just pure white, but realistically may have a vanilla, or light yellow or orange tint. See article [[ANSI White]]. | ||
| Line 207: | Line 207: | ||
;showerhead: a flashlight with a cluster of low-powered LEDs. Generally these are very inexpensive lights (9 LEDs seems common), but some have hundreds of LEDs and actually give off a decent amount of floody light. | ;showerhead: a flashlight with a cluster of low-powered LEDs. Generally these are very inexpensive lights (9 LEDs seems common), but some have hundreds of LEDs and actually give off a decent amount of floody light. | ||
;SinkPAD: a brand name of LED MCPCB that is designed to conduct heat away from an LED more efficiently than typical boards, therefore keeping the LED cooler, increasing brightness and LED life. | ;<span id="SinkPAD">SinkPAD</span>: a brand name of aluminum or copper LED MCPCB that is designed to conduct heat away from an LED more efficiently than typical aluminum boards, therefore keeping the LED cooler, increasing brightness and LED life. Also see [[#Noctigon|Noctigon}}. | ||
;SMD: Surface Mount Device - most high-power LEDs used in flashlights are mounted this way where legs of a component (LED, capacitor, resitor, diodes, etc.) are soldered to pads on the surface of the circuit board (as opposed to through-hole soldering where the legs of the LEDs go into holes on the circuit board which are then soldered on the underside with the excess leg length clipped off). | ;SMD: Surface Mount Device - most high-power LEDs used in flashlights are mounted this way where legs of a component (LED, capacitor, resitor, diodes, etc.) are soldered to pads on the surface of the circuit board (as opposed to through-hole soldering where the legs of the LEDs go into holes on the circuit board which are then soldered on the underside with the excess leg length clipped off). | ||
;<span id="SMO">SMO</span>: a reflector with a smooth finish. Designed for better throw, but also shows imperfections in the LED (e.g. rings). Compare to OP. | ;<span id="SMO">SMO</span>: a reflector with a smooth finish. Designed for better throw, but also shows imperfections in the LED (e.g. rings). Compare to [[#OP|OP]]. | ||
;spill: the area of a flashlight beam outside of the hotspot and corona. Light intensity in the spill area is typically low and even, and comes directly from the light emitting surface with little or no contribution from the reflector. | ;spill: the area of a flashlight beam outside of the hotspot and corona. Light intensity in the spill area is typically low and even, and comes directly from the light emitting surface with little or no contribution from the reflector. | ||